XL twin platform bed is stylish and modern alternatives to expensive furniture. These beds, essentially stacked boxes on top of each other, can be built with or without gables and can be easily handled as children grow up. Rolling bearings or rollers increase the versatility in apartments and small rooms. Build a double-sized platform for small children or teens used as sofa beds and with a standard mattress, foam mattress or futon. Build the box below with 10-inch planks and a platform with 1 x 4-inch planks. When placing boards on the sides, you have a height of 14 inches. Add two 1-inch thick plywood panels. Finish with a mattress 4 inches thick and your bed will reach a height of 20 inches. It’s a nice distance for an adult, but you can use shorter sides for a bed or just build the box 10 inches tall. Add the platform later as she grows up.
Mount a base box on the head and mouth of the portrait on the sides and attach them to the sides with L-shaped brackets or wooden corner blocks. Cut three or four toothbrushes of the same size, but cut them 1 1/2 inches shorter than the head and mouth because they come in between the sides instead of them. Secure the brackets with screws and L-brackets to the XL twin platform bed. Slide the wood wire around the top of the pedestal sides and seal it and cut it with 3 / 8 thick plywood or cut in MDF to secure the top of your base.
Make the sides and ends of a platform at least 4 inches longer as you cross the base. If you finish only with the base or the base and the platform, your top surface should be a few inches larger than the width and length of the mattress. This allows space so that children do not bump their toes. Repeat with boards on the sides that form a box, attach the corners with the L-shaped brackets and insert the slats into the mount. Lift the platform to the base before adding plywood or MDF tires. Make sure all the clips on the platform rest on the base. Attach each dressing to the tire using L-clips and tire bolts. Place the glue on the side of the XL twin platform bed and seal and gently deposit the plywood. Screw the tire for the braces with tire screws. Sand all edges.